Autel Support Communities
Autel Support Communities
Welcome, Guest     Sign in
Communities > Diagnostic & Analysis System > MaxiSys > Merc Programming
Merc Programming

2394 Views 5 Replies Latest reply: 2015-09-23 02:19:25


  •   Level 4   
    (117) points
    JulesD
    2015-09-22 02:13:26
    Today I had a ML500 Merc vin WDC1641752A059083

    I went to program to Front SAM module today but was unsuccessful to start with after following the guide.  It failed and shows a red screen on the dash of the car saying "take to workshop" or something, and wouldnt start.
    It took me about 6 goes to get it to work.  In the end I had to turn the ignition on and let the update run, where the MS Elite told me to have the ignition off quite a few times in the process.  I didnt log it because I was freaking out by this time that I was going to need to send it to Mecredes for repair.  Can this be updated or looked at.

    Also, I successfully programmed the Air Con software update to fix the issue of the controls not functioning properly but I had to do this function about 3 times to get it to work.  It just went into a loop saying the Reset was successful but the next screen said it was starting again in 9 seconds.

    Maxisys Elite - updated all the way :)
    Reply

  •   Level 9   
    (3413) points
    Support02

    2015-09-22 03:39:54 (Reply to:JulesD)

    Sorry, after checking, there is something wrong in our software. We will analyze to correct it soon.
    Reply

  •   Level 10   
    (7578) points
    witsend

    2015-09-22 15:18:43 (Reply to:Support02)

     Is the Maxi Sys Elite  at present time still being Beta tested , or has it been officially released for sale?
    Reply

  •   Level 4   
    (117) points
    JulesD
    2015-09-22 18:15:21 (Reply to:Support02)
    Thanks guys.
    I will be using it every day from now and will post up or send a log for as much as I can.
    Do you want a separate thread for each issue or just start a Maxisys Elite bug thread?
    Reply

  •   Level 9   
    (3413) points
    Support02

    2015-09-23 01:57:09 (Reply to:witsend)

    Hello Witsend, Maxisys Elite has been launched officially to the market. 
    Reply

  •   Level 9   
    (3413) points
    Support02

    2015-09-23 02:19:25 (Reply to:JulesD)

    We will set a community for Maxisys Elite in this Forum. In the future, you can feedback your problem in that community. 

    And also for urgent issue, it is strongly suggested you can send your problem to support@autel.com with your datalog, so that we can follow it in time. Thanks.
    Reply
1
  Total1 Pages
Last Post Next Post Go to original post Reply to original post
Related links
Top users
Online users
Search Communities